Nooteboom has further expanded their EURO-PX low-loader programme. The latest addition is the 4-axle IC Interdolly Compact which, combined with 6 steered pendle axle lines at the rear, is now the largest low-loader combination in the Nooteboom EURO-PX low-loader programme. The first 4+6 low-loader combination, type EURO-147-46(ICP), is going to C. Zwagerman Transport from Nederhorst den Berg (NL). This combination has been optimised for the German regulations: an axle load of 12 tonnes at 80km/h, so that loads of 100 tonnes can be transported efficiently in and to Germany.
Latest and largest Nooteboom 4+6 low-loader provides Zwagerman Transport with a load capacity of more than 100 tonnes in Germany
Optimised for German exemptions
Cor Zwagerman, director/owner of C. Zwagerman Transport: “The cranes and machinery that we transport are getting heavier all the time. This new low-loader is the largest that Nooteboom has ever put on the road. With a German exemption the load capacity is just over 100 tonnes and this enables us to enter a new segment of the market. This Nooteboom 4+6 low-loader has several advantages for us. In order to adapt the low-loader, as far as possible, to comply with the German regulations for exemptions, the axle distance has been increased to 1.51 m instead of the usual 1.36 m. In practice this means that due to this larger axle distance, which minimises the load on bridges and viaducts, the exemptions in the various federal states of Germany are easier to obtain. Another advantage is the close coupling system which makes it easy for us to convert the trailer into a 10-axle semi low-loader. In this configuration the load capacity increases to around 110 tonnes and the steering of the Interdolly can easily be adjusted to this shorter configuration.
The relationship between Nooteboom and Zwagerman goes back more than 50 years and this gave us enough confidence to award the order to Nooteboom.”
“The relationship between Nooteboom and Zwagerman goes back more than 50 years and this gave us enough confidence to award the order to Nooteboom.”
Cor Zwagerman: “By choosing the 4+6 low-loader of Nooteboom, all the components – such as the gooseneck, Interdolly, load floor and axle assembly – are universally exchangeable with our 3+5 EURO-PX Nooteboom low-loader. This means we can put no less than 14 different configurations on the road and for us this is an economical and efficient alternative to modular trailers, which are complex and more expensive.”
When purchasing the latest 4+6 Zwagerman opted for a flat, shallow, 2750mm wide extendible floor as well as a narrow spine floor for the transport of large tracked vehicles. This spine floor also comes with mattresses to extend the load floor’s width, in a high or low position. The Interdolly with 4 axle lines is optionally equipped with a hydraulic landing leg which makes it even easier to couple/uncouple the load floor and the Interdolly. The gooseneck of the low-loader can be used on a 4-axle or 5-axle tractor.
Driver Paul van Wijk: “In our company several drivers must be able to operate a low-loader. This is no problem because the Nooteboom trailers are simple and intuitive to operate, especially in comparison with modular trailers and their complex operation. I drove the first Nooteboom low-loader with an Interdolly ten years ago. At first I did not see the advantage. In those days we had been working with a Jeepdolly for years. Initially I thought the smaller steering angle of the 1st generation Interdolly would be a disadvantage. But in practice this was not a problem and the new Interdolly now has a steering angle of up to 70 degrees. This makes the combination much more manoeuvrable than before and reversing is much easier than with a Jeepdolly.”
In 2005 Nooteboom brought the revolutionary EURO-PX low-loader on the market. For the first time a wide and deep excavator trough was combined with pendle axles in the axle bogie. The EURO-PX low-loader with patented Pendel-X technology proves to be an important addition for low-loader transport. Not least because it combines an excavator trough and the easy operation of a conventional low-loader with the load capacity, steering and stroke of a modular trailer.Read more
For extra load capacity and optimal weight distribution the Nooteboom EUROTRAILER low-loader can be combined with an Interdolly, fitted at the front between the gooseneck and load floor.Read more